Bouncing off the Walls
by Fiona Bayrock
How's the music in your room? Too much treble or bass? Not enough? Got extra sound bouncing around? Do certain notes always jump out at you? Check the acoustics—the sound qualities of your room.
Whether your music sounds great, barely passable, or downright awful depends on how sound waves behave when they hit different surfaces. As a rule, sound waves are reflected by hard surfaces and absorbed by soft ones, but most materials absorb and reflect high-frequency (treble) and low-frequency (bass) sounds differently.
To improve the acoustics of your room, look first to the largest surface areas—the walls, ceiling, and floor. Wood absorbs bass tones; carpet and heavy or thickly gathered draperies absorb treble; and glass, tile, concrete, and polished stone are highly reflective.
An important acoustic effect to consider in a small room, such as a bedroom, is reverberation. Large, flat, parallel surfaces, such as two walls, or the floor and ceiling, can reflect sound waves back and forth. The reflected sounds may reach your brain while the original sound is still there, but too late for the brain to register the reflected sound as part of the original. The sounds partially overlap in the brain, with the result that you hear them at the same time as a “prolonged” sound.
Reverberation is especially noticeable as extra sound in an empty room. But your furnished bedroom may also reverberate strongly to music of certain frequencies, causing specific notes to jump out each time they're played. Reduce reverberation by making the shape of your room more complex. “The wavelengths of audible sound in air can range from less than an inch to tens of feet,” says Dr. Dewey Lawson, a physicist at Duke University. “Ideally, the boundaries of listening rooms should be ‘rough’ [and] over that whole range of sizes.”
Bookshelves with books, plants, or collectibles; a wooden mask collection hung on the wall; posters mounted on foam board; pictures in deep frames; a coat rack; clothing hooks; pillows; furniture of varying heights; chunks of fabric-covered spongy foam scattered across the wall—anything that helps break up large flat wall areas—will help reduce reverberation between walls and contribute to a feeling of full and lively sound in your room.
“Typically, treating only one of a pair of opposite walls will suffice—or treating different parts of the opposite walls,” explains Lawson. Increasing the complexity of either the ceiling or the floor will also reduce reverberation between them. Aha! Clutter makes for better acoustics. At last, a scientific reason for having a messy room!
- Draw a diagram of a bedroom as if you were looking down into the bedroom from the ceiling. Include the kind of furniture that you might have in your bedroom, such as a bed, a desk, or a bookcase. Against one wall, draw a bureau or a dresser with a stereo on top of it. Now imagine that the stereo is turned on and playing your favorite kind of music. Is the music playing loudly or softly? Does the music have high pitches and low pitches? Think back to the sound waves that were shown in Lesson 2. Draw the kind of sound waves the stereo would produce. How would they move through the room? How would objects in the room change the direction of the sound waves? How would the objects absorb the sound waves? After completing your diagram, write a few sentences about how the sound waves move through the room and how the furniture and the shape of the room affect the sound waves.
[anno: Diagrams will vary but should show a bedroom with furniture and a stereo, with one or more types of sound waves traveling from the stereo through the room.]